IH-888-XHS - 25oz Selvedge Denim Medium/High Rise Tapered Cut Jeans - Indigo
-
Potentially dumb question: would the reported shrinkage of ~1” inseam be expected with a cold soak, or might the shrinkage be less/mitigated?
Found a pair that are already hemmed. The current length is pretty much my minimum, couldn’t go any lower. If I could get away with cold soaks only to avoid losing the length, it might be worth the purchase. Cheers.
-
I've hot-soaked, hot-low-agitation-washed two pairs of these and never got more than 0.25" of shrink on inseam. Granted, they were already hemmed by IHUK, so they were like 32.5" before soaking. I assume that I would've seen more shrink had they been the default ~36" length.
YMMV, but I would say that a cold soak is probably fine in that you won't get a ton of inseam shrink. I think the greater concern is shrink while washing, which you will probably have to do eventually. If you're okay with committing to a lifetime of cold low-agitation washes with these, you probably won't see much shrink there either. And, if you look at what I wrote above, you may not even get much shrink with a hot wash, either.
Just make sure you line-dry, not machine-dry, for lots of reasons
-
That’s enormously helpful, thanks a bunch @Paul9221
I’ve never had a pair of jeans hemmed, I just cuff and roll. Hence my trepidation. I’ve measured the inseam of my current pairs to the point at which I tend to cuff my jeans to, which is 30”. The pair I’m eyeing are hemmed to 31” so on paper I’d be fine with a small cuff. Wouldn’t wanna lose that extra inch, so I’d have to be very careful…
-
Look ma, no hands!
I never thought I would have a pair that stood up on their own, but here we are. The upper block is awesome, comfy. The rear goes a good few inches higher than many of my other pairs. I do wish there was a bit more taper below the knee, but i imagine that is a symmetrical issue.
And the craziest thing that will be said today: these 25oz feel so light compared to the double knee bibs its like im not wearing anything! They feel like “normal” jeans at this point. I think ive gone mad. They arnt even soft yet and feel like a good pair. I had them hemmed but still have way to much, so probably going to do a tight japanese cuff.
One thing i noticed that i thought was super weird, some of the stitching is different color. So like the left pocket and left fly are one yellow/gold color, and the right side of the fly is a different yellow/gold color. Why is that?
-
Hey [mention]jerkules [/mention] I don’t think whether a pair is hemmed or not will influence whether or not you see inseam shrink with washing. That is strictly dependent on the way the denim as a whole responds to water. The part I do agree with is that you’ll see minimal shrinkage if you always cold wash with low agitation.
Sent from my iPhone using Tapatalk
-
One thing i noticed that i thought was super weird, some of the stitching is different color. So like the left pocket and left fly are one yellow/gold color, and the right side of the fly is a different yellow/gold color. Why is that?
can you make a picture?
-
Thanks @sabergirl for your input. I probably didn’t explain myself correctly earlier - normally I don’t get my jeans hemmed, and therefore have lots of extra length to play with. If I were buying a new pair of XHS direct from IH, I’d size by my usual crucial points: waist, thigh etc but wouldn’t even consider the length/shrinkage. I’d just cuff it where it felt good once I’d got the shrinkage out. Sizing for length adds an additional factor that’s outside of my experience. Since I’ve never tried to determine the “sweet spot” with regards hemming, I’m now finding it tricky. Add potential shrinkage and I’m even more adrift lol.
In any case, I’ve decided to pass on the like new pair I saw. 31” is just too close to the wire for me, and I do like to have a little cuff. I’ll hold out for when I can afford new from IH.
Thanks for the help y’all.
-
One thing i noticed that i thought was super weird, some of the stitching is different color. So like the left pocket and left fly are one yellow/gold color, and the right side of the fly is a different yellow/gold color. Why is that?
can you make a picture?
Here you go. Don’t mind the dry wall dust:
Adding a pantry in the garage and it’s a good break in for the 888’s.
-
Looks like self edge just got a load of IH-888XHS.
On another note, my 21oz 888s have the two tone stitching too.
-
One thing i noticed that i thought was super weird, some of the stitching is different color. So like the left pocket and left fly are one yellow/gold color, and the right side of the fly is a different yellow/gold color. Why is that?
Completely normal on properly made jeans, there are in fact about 12 or 13 different yarn types used in the construction. of a single pair of jeans, each selected for the properties needed for a particular function…..
-
@Noahf I just checked and mine have the same thread color variation that you are seeing on yours.
what a brilliant pair of pants and what an amazing fabric.
-
@jordanscollected beautiful evolution. Couple weeks in and softening up nicely for me. Loving this material and trying to practice some self control and hold out for the XHSib restock (whenever that may be) instead of settling for the upcoming release of the 21oz ib… wish me luck w that!
-
wow @Bren those look great! How did you size them? they seem to have a slimmer silhouette than mine. I'm 5'11 and 185 and bought size 35 waist. My No Lots are 34's and they still fit larger in the waist than the 888xhs due to the high rise.
-
@Paul9221 you bugger! Literally read my mind on the 19oz lefty. That is the last on my list for IH Type 3s
-
Much appreciated @jordanscollected. It took a lot of trial and error for me to be able to properly translate my measurements. I’m 5’11 160lbs and went w a tag 30 and have a tag size 31 in the 21oz OD that fits identical. Up till recently, I was buying at least a tag size too large (as you touched on w your no lot, mostly overlooking how the rise makes a difference on where the jeans sit; on the waist or hips. So for me, 31.5” waist on 777, 31” on 555 and 30.5 on 888). I have no place in giving you direction going off your IH history and your awesome WAYW posts but for your next 888 purchase, try going in a half inch to an inch tighter on the waist to what your XHS tag 35s are coming in at for a slimmer profile; bet you could pull it off
-
@Paul9221 stumbled upon the new products portion of the forum am am now realizing that you are not talking on restocks in Type 3s. This hurts my brain. Do you have experience in either the UHR or lefty and how they differ? Sounds like I’ll need to budget accordingly indeed.
-
@Bren:
@Paul9221 stumbled upon the new products portion of the forum am am now realizing that you are not talking on restocks in Type 3s. This hurts my brain. Do you have experience in either the UHR or lefty and how they differ? Sounds like I’ll need to budget accordingly indeed.
LOL, no worries! I don't have any experience with the 19oz lefty denim that I know of (I'm pretty sure I don't own anything with that fabric), but I do have some experience with the 21/23oz UHR, at least the last iteration (I don't know if anything's changed in this round). The UHR is something amazing. For me, it was a fast fader and it faded in such a lovely way.
Check these forum threads out:
-
Good looking out @Paul9221 blanket-lined fist bump
